Then wipe it over using a dry microfiber cloth. Be sure to reach into awkward areas such as the ports and around the analogue sticks. First, disconnect any cables, then blow compressed air all over the controller to remove any immediate dust. Thankfully, cleaning a PS4 controller is much more simple. If you have a PS4 Slim or PS4 Pro, there are no screws. If you have a later original PS4, there's just one sticker and one screw. Then safely keep them together and set them aside. These hold the outer case in place, so unscrew these using a T8 or T9 Torx screwdriver - we recommend Teckman ($6.59, Amazon (opens in new tab)). If you have an original PS4 as pictured here, you should notice four screws on the rear of the console, beneath the warranty stickers. If it’s still under warranty, it shouldn’t need cleaning.Ħ. Remember, if it’s still under warranty, contact customer services rather than cleaning the internals yourself. If this is your first time cleaning your PS4, and you have an original PS4, you’re going to need to remove the warranty stickers from the rear, not least because you'll also need to remove the screws beneath them. First make sure you’ve cleared some space and have a good source of light to see what you’re doing.ĥ. Now comes the tricky part: cleaning the internals. This clears away any potential dust your PS4 may collect once back in place.Ĥ. While you have this cloth to hand, wipe the surface and around the area where your PS4 sits as well. Next, run a dry microfiber cloth along the surfaces of your PS4 to get rid of obvious dust. Reconnect all cables and turn on the console.3. You will hear an audible click when the cover is secured. Replace the bottom cover by positioning it slightly away (about 2cm or 3/4 inch) from the top edge and sliding it back into place. Do not forcibly pull the disc from the optical drive.
Using a #1 Phillips or a cross-hatch screwdriver, turn the screw CLOCKWISE until the full disc is almost completely visible. (Newer consoles may not have this plastic cover.) You can remove this film, or push through it to reach the screw it is covering. With the cover removed, look for black rings on the optical drive, including a circle of black plastic film. Gently pull the cover up and toward yourself. Place your palms near the top corners and grip the edge of the cover.
Position the console so the screw hole for the base is facing you, the PS logo is facedown, and the disc slot is on your left side. Place the console on a soft cloth on a flat surface and remove the base. Press and hold the power button for three seconds to turn off your PS5 console, then remove all cables and devices from the console. Note: Don’t turn on or play on your console with the cover off. How to remove a stuck disc from a PS5 consoleĪ #1 Phillips or cross-hatch screwdriver.
0 kommentar(er)
